|
Decorative Film Instructions
Our site features Vinyl Etched Glass Decals, Decorative Glass Film and Screen Art Magnets.
|
NOTE: Read All Instructions Before Application
(This is a simple process! However, patience and preparation are very important.)
Tools Needed: Scissors/Razor Knife, Tape Measure/Ruler, Squeegee, 32 oz Spray Bottle,
Lint-free Paper Towels, or Soft, Lint-free Cloth (Micro-fiber)
1. Clean all areas where the film is to be applied, removing all traces of dirt, grime, grease, etc.
2. Carefully measure height and width of the area of application. Cut film to fit or, cut 1” wider and
1” longer, then trim film for exact fit once applied to surface and after first squeegee process.
3. Use film-aid application concentrate, if available by your dealer, or create your own wetting solution
by adding a few drops (only a one-second squeeze) of either Johnson Baby Shampoo or Joy Dish Detergent
into a 32 oz spray bottle and then fill with water.
4. Turn off all fans and any AC/heating ventilation ducts in your working area.
5. Lay the cut-to-size decorative film on a clean flat surface with the release liner up, or have someone
hold piece to be applied for you. Remove the release liner. (See "Tips" below for easy liner removal.)
Spray the now exposed adhesive film surface thoroughly with wetting solution. Note: when using the
larger-sized film (36” x 76”), two people are definitely needed for easy application.
6. Next apply a generous amount of wetting solution to the glass. Make sure it is dripping wet; too much
solution is better than not enough! And, by wetting both the film and glass, it prevents the film from
sticking to itself and to the surface immediately, thereby allowing you more time in which to properly
position the film. If either surface were to become dry before applying, rewet completely.
7. Place the wet adhesive side of film against wet glass surface. Start at top of surface, then allow film to
gently lay down on the glass. You can slide film around positioning it correctly so long as the window and film
remain thoroughly wet. For ease in squeegee process, lightly spray the face of the film. Now start to squeegee
out wetting solution, working from the center out toward the edges. Double check that the film is flat and
smooth with no remaining air bubbles. It may be necessary to again spray the face of the film and squeegee to
release any remaining moisture.
8. If, at this point you did not cut the film to exact size, use your ruler to trim along edges with a straight edge
razor. It is ideal to cut in one continuous movement and to use a new blade tip after 3-4 cuts. Carefully dry any
excess wetting solution that appears around the edges.
TIPS:
The film begins to adhere in 30 minutes and cures fully over 3-5 days. During the drying process, it could initially
look hazy, cloudy, or spotty. However, this effect will disappear over a short time. Dry, sunny weather speeds
curing while wet and/or cold temperatures may possibly prolong it.
All decorative adhesive films have a liner applied to the back of it. To easily remove liner, apply a piece of tape
on a corner edge and another on the same edge of the backside of the film. As you peel tape apart, liner should
peel away. Caution: Take care as you remove the release liner and do not let the film roll over on to itself as it
will stick together and be difficult to pull apart.
A stubborn, remaining air bubble or two that have not been worked out during your final squeegee process can
be removed by using a straight pin to pop and then work out the air gently with your finger.
To clean the film, a very light, mild soapy-water solution should be used and then wipe over with a soft, damp cloth.
DO NOT USE AMMONIA, VINEGAR, HOUSEHOLD GLASS CLEANERS, PAPER TOWELS, OR BRUSHES.
Window film absorbs up to 98% of the harmful ultraviolet (UV) rays thereby protecting your furnishings and aids in
glare and heat reduction. Light is dispersed softly, rendering a high-class, tranquil atmosphere, which reproduces
a beautiful etched-glass appearance not typically found in window films.
When properly applied and cleaned, your decorative film will give you years of enjoyment, privacy and security, and increases personal safety from glass breakage. Overall product life is affected by climate, geographic location, and exposure to the sun.
Removal is easy. It can be peeled away. For larger areas, you may want to spray with an adhesive-remover first.